Ceiling Fan Installation in Altadena, CA

A ceiling fan is one of the cheapest ways to make an Altadena summer more bearable, and one of the most common jobs homeowners try themselves and get wrong. The fan is heavy, it moves, and it hangs above the people sitting under it. It needs to be mounted to a box rated for fan support and wired to a circuit that can take it. We install new ceiling fans, replace old ones, and add the wiring and controls that let you run them the way you want.

Ceiling Fan Installation and Replacement

Most fan jobs fall into one of three types:

  • Replacing a light fixture with a fan. The existing box is usually rated for a light, not a fan. A fan’s weight and wobble can work a standard box loose over time, so we replace it with a fan-rated box or brace secured to the framing.
  • Replacing an old fan. We check the box, the support and the wiring. Older homes often have fans hung from boxes that were never rated for them.
  • Adding a fan where there was nothing. New wiring from a nearby circuit, a new fan-rated box, and a wall switch or control. In older plaster-and-lath ceilings and homes with limited attic access, we plan the cable route to keep patching to a minimum.

Switches, controls and smart fans

A fan and its light work best on separate controls. Where a ceiling only has one switched cable, we can run a new cable for independent fan and light switching, install a fan-rated speed control, or fit a remote or smart control. Ordinary light dimmers are not designed for fan motors and can make them hum or overheat.

Clearance and placement

Most manufacturers call for blades at least 7 feet above the floor and a minimum clearance from walls. On high or sloped ceilings we use the right downrod and a sloped-ceiling adapter so the fan hangs level and runs quietly. Outdoor fans on patios and covered porches must be damp- or wet-rated for their location.

Attic Fans and Whole-House Fans

Foothill summers drive attic temperatures very high. That heat soaks into the rooms below and makes air conditioning work harder. Two kinds of fan help:

  • Attic ventilators pull hot air out of the attic space. Powered units need a circuit and usually a thermostat or humidistat control.
  • Whole-house fans pull cool evening air in through open windows and push hot air out through the attic. They need a dedicated circuit, correct attic venting, and a timer or control.

Before adding either, we check that the attic has enough venting for the fan to work and that existing attic wiring is in safe condition. Older homes sometimes still have knob-and-tube in the attic, and it should not be buried under new insulation. If it is, see our whole-home rewiring service.

Bathroom Exhaust Fans

A working bathroom exhaust fan prevents mould, peeling paint and damaged drywall. California’s green building standards call for humidity-controlled exhaust fans in bathrooms with a shower or tub in new and remodelled work. We install and replace exhaust fans, add humidity sensors or timers, and duct them outside rather than into the attic. A fan fitted over a tub or shower must be listed for that location and, where the manufacturer requires it, GFCI-protected.

Why Use a Licensed Electrician for a Ceiling Fan

  • Support. A fan hanging from an unrated box is the most common failure we see, and it can fall.
  • Circuit capacity. Adding fans, especially several at once, can overload a bedroom circuit that already serves lights and outlets.
  • Wiring condition. Opening a ceiling box in an older Altadena home often turns up brittle cloth insulation or missing grounds that should be dealt with while the box is open.
  • Permits. New circuits and new wiring generally need a permit. For Altadena addresses that comes from LA County Building & Safety. Swapping a fan on an existing, suitable box usually does not.

Related Services

Fans are often part of a larger lighting or comfort upgrade. See lighting installation, outlet and switch installation and general electrical repairs. If a fan or its light flickers, hums or trips a breaker, our troubleshooting service will find the cause.

Frequently Asked Questions

Can I replace a light fixture with a ceiling fan myself?

Only if the box is fan-rated and securely fixed to the framing, and you are comfortable working on a de-energised circuit. Most light-fixture boxes are not rated for a fan, which is why we replace or brace the box as part of most installs.

Do I need a permit to install a ceiling fan?

Replacing a fan or a light with a fan on an existing, suitable box usually does not need a permit. Running new wiring or adding a new circuit generally does. For Altadena addresses, permits come from LA County Building & Safety.

Why does my ceiling fan wobble or hum?

Wobble usually comes from unbalanced blades, a loose mounting or a box that isn’t fan-rated. Hum is often caused by a standard light dimmer used as a fan control. Both are worth fixing: a loose fan can work its way off the box.

Call (626) 768-1402 or request service online. Office hours are Monday to Sunday, 10 am to 10 pm.

Pricing: Standard service call fee applies. We quote the fee on the phone before we dispatch, and credit it toward the repair if you go ahead.